Posted by TJ in KY on October 10, 2013 at 12:56:41 from (220.127.116.11):
This is on an Allis Chalmers 175 diesel,
Does anyone have a fix for this hydraulic driveshaft from the engine crank to the hydraulic pump. I was concerned it was going to be expensive BUT it turns out the flange with isolation dampeners and the shaft, pto splined on one end, are no longer available at my local AGCO dealer
I am looking for ideas. I thought about having it bored out and new shaft made and welded to the hub, but I don't know how true it would run after welding.
Looking for ideas from any body that has done this repair or any machinist with ideas about retro fitting this hub and shaft.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.