Posted by BushogPapa on August 05, 2013 at 19:04:25 from (173.88.51.117):
In Reply to: WD Manifold Studs posted by WayneMo on August 05, 2013 at 16:14:09:
I replaced all the studs on my WD 45 with hard bolts of the proper length, with a hard washer under each bolt head.
I use Black Gasket-Maker on the threads.
As for the gaskets, I rub Hi-temp Silicone into the asbestos, stick the gaskets into the metal cups and stick them onto the manifold runners.
Makes an easier way to install them and I think the gaskets last longer this way.
You don't want to make the mounting bolts overly tight on the ends, the manifold needs to be able to slip as the manifold expands and contracts. Graphite might be good on the side next to the Head..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.