I suspect your friend may be confusing carbon core suppressor wires (NOT best thing for Magneto Ignition) with stranded wire core (better for Mag Ignitions) plug wires.
Still even if it had carbon core suppressor wires that alone dont stop her from firing.
Even oxidation on point surfaces can prevent a mag from firing, let alone carbon and burns and pits (much worse). Id non abrasively as possible try to clean/buff/polish the points n check the gap and try her. You could even drag a dollar bill (a $20 may do better lol) between the surfaces n see what happens. For carbon or pitting a points file may be more in order, but once you over file them a lot they dont last long.
Of course, she cant fire at low cranking speed unless the spring wind n trip impulse assembly is working, although they can still pull start n run if thats the case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
