I used a roll pin just a little longer than the "hub". Each end of the roll pin sticks out about 1/8 inch. (Grind the roll pin to proper length before installing.) Then flare each end of the roll pin with a good (large enough) center punch. (Back up the other end of the roll pin when flaring each end.) Then install a smaller roll pin that fits (snugly) inside the first roll pin. (Refered to as "nested" roll pins.) Flare each end of that (smaller) roll pin also. If you have concerns, clean everything well before assembly and "lubricate" everything with "Blue Loctite".
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.