Posted by Will Herring on November 10, 2012 at 18:13:53 from (50.103.230.183):
I need to add some hydraulic oil to my WD, and I see that the manual says "for above 45 F, use SAE 20, and for below 45, use SAE 10"... Well, does anybody have any idea what I can use? I know a neighbor said he uses the same 10w30 he uses in the engine for his hydraulics. Didn't know if I actually should get SAE 10 (can be hard to find here, I think) or if I should find some sort of universal hydraulic fluid (or if mixing that with whatever is already in there would be bad).
Also, apparently there are two different fill plugs for the tranny/diff (but 3 drain plugs)? Do you just fill the tractor until it is full to the top of the plugs, or is there some sort of fill mark without draining and refilling the whole thing? Was going to use some 80-ish weight oil in that. The manual says "fill to level plugs", but I only see it call out the 2 fill plugs in the lubrication manual. Where are the "level" plugs for this system?
Also, anything else I need to grease with regular grease, like the clutch? Also, I think the PTO is lubricated from the tranny/diff reservoirs, but are there some grease zerk fittings on it I should hit up as well?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.