Posted by BushogPapa on October 25, 2012 at 20:54:59 from (220.127.116.11):
In Reply to: Re: main brngs posted by Aaron SEIA on October 25, 2012 at 18:42:41:
On these, you don't "just roll in new bearings".. You must adjust the shims on each one..
Oil pressure can be affected a great deal on these by the Back-Pressure (restriction) to flow in the standing tube, in the oil filter.. Are you sure it is in there..?? Few gauges will read accurately at such a low pressure..even AC gauges vary.. Put one on from an AC that shows proper oil pressure, to check your gauge..
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.