Posted by BushogPapa on August 27, 2012 at 12:26:19 from (173.88.51.117):
In Reply to: 201 into a 226 posted by Dave in SC-NE. on August 26, 2012 at 16:48:52:
One question..??? When did AC go away from a combustion chamber in the HEAD.?? I know that the WD-45 and D-17 Gas both have a flat head..are all WC's Flat Head..??
For a little more compression, you can put the "D-17" 4 1/8" kit in it.. That will give you 7.4:1 Standard WD-45 gas is originally 6.5:1 7.4 is about the "Limit" for working in the field, but is not critical to tune.. Same price for either piston/sleeve kit.. Probably will require 12Volts to spin it over, or 1/4 turns on the crank...won't be spinning it with that size and compression..but will crank, if you want or need to..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.