Posted by RalphL on August 08, 2012 at 09:37:57 from (188.8.131.52):
In Reply to: Re: G Carburetor posted by soundguy on August 08, 2012 at 06:33:53:
Yesterday afternoon I took it apart again. Everything looked good but I adjusted the little wire that helps pull the needle out when the gas in the bowl goes down. I left the air inlet tube off so I could easily tell if it leaked during the night. This morning there was a maybe several drips on the floor. Not a flood like before. I am going to call it good and use it as is. I also plan to shut the gas off after use as you and others have suggested. Thanks
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.