Posted by Billy NY on April 16, 2011 at 07:54:26 from (74.67.3.54):
I was wondering, after repairing a single strand fence, which has wood posts, 1"x6" wood top rail and steel mesh/ag type/livestock fence below the top rail to the ground, stapled to the posts about testing same.
The charger is a 5 mile Zareba, plug in receptacle type, the run is 350-400 feet or so, 3 copper clad earth grounds, 3 feet into moist soil,(cannot get any deeper) properly clamped and #10 copper wire, feeder to electric strand is same, no splices, insulators are good, nothing touching. Feeder is securely twisted together, wire nut tightened, and tightly sealed in electrical tape copper and galvanized steel wire are dissimilar metals/materials, so maybe it will oxidize at some point. Used to be common to find stainless steel wire when I was a kid, must be too expensive now.
At the charger, the tester reads 4000, its a black plastic case, inexpensive type, has 5 filaments that illuminate, you have to shade to see them, I think max is 5000, I assume measured in volts, but am unsure for this application what that means. Electric fence for dummies
Test at the strand, it reads about the same, 4000, however, you can keep your index finger on it, feel a tingle, then bridge with your thumb and hardly notice it, however move that thumb down to the metal fabric/livestock fence, you get a real nice jolt, you cannot hold your hand there. What I am wondering, does a horse with front shoes on, in moist ground, get the same jolt or is he getting what I described for the index finger ?
Our stallion lives in here, he's a well mannered, friendly fellow, never any trouble, really kind of an exception, I trust him more than any other horse in the barn, all the riders love this guy. The only reason for the strand is, he cribs and knocks the rails off sometimes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
