Posted by Bill in IL on April 05, 2011 at 07:15:38 from (131.43.10.35):
In Reply to: wire welder posted by Tom Schnitzler on April 05, 2011 at 03:51:57:
My experience is with a lincoln sp135. I bought it 10 years ago and have been very happy with it. It has the infinitely variable voltage control instead of steps that is very handy for light guage metal.
If you are going to buy one make sure it can run shielding gas, not just flux core wire if you plan on welding light guage metal.
If I had to do it over again I would have bought the same size machine but a 240 volt model. It gives you slightly more duty cycle, slightly higher output current, and to get full potential out of a 120v machine you need to be on a 30 amp circuit.
In the long run I think you should stay with a miller or lincoln. You will be happier.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Reflections of the Fifties - by "Country" Elliott. I remember rowing up in the 1950�s in a small, rural town in northwestern New Jersey. The closest town to ours was only 3 miles away, and there were seven dairy farms in the areas of these two country towns. We had 5 acres, and because my Dad was a salesman and not a dairy farmer, he let the Bockovens, who owned the Willow Tree Dairy farm most of our land.
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
