Posted by bruster on April 03, 2011 at 06:26:00 from (98.27.230.190):
In Reply to: OT: Back surgery posted by 1950whiteC on April 02, 2011 at 12:48:11:
Had my operation in '04, after doing the nerve blocks and the therapy route. Had to walk around with 2 arm canes because of sciatic nerve pain in both legs. Surgery opened nerve cord areas that had been pinching, and fused L3 that had sipped out of line, along with trimming the insides of the 3 bulging disks. Was fine after, and went back to the work I was good at in 7 months as a truck road mechanic. After 2 years, and being careful, I'm back in the same shape with anterior muscle pain both legs, and spasms that drop me to the floor when not expected. Bottom line.....It will make you better, but you cannot jump in and do everything you might have done before.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
