Posted by s.crum on March 27, 2011 at 07:44:50 from (12.75.110.162):
In Reply to: Re: O/T- Meth?? posted by George Marsh on March 27, 2011 at 07:12:38:
No I'm in Northern central Pa. the original "meth valley". A kid I went to school with was one of the people that refined the methods of cooking meth back in the 1980s. Thru the 90s and until recently Meth labs dotted the landscape in this area. Law enforcement finally woke up and started educating people and really getting rough. This drove the "cookers" out to places like Indiana and the midwest. That stuff isn't real conducive to being made in a populated area as it smells quite bad as I'm told. We had people getting shot stealing ammonia and most other chemicals. If you bought starting ether you got real suspicious looks. All cold medicines you still need to show ID to buy. This area was initially popular for producing that stuff due to it's rural "charm" but close proximity to NYC, Philadelphia, Baltimore/Washington. Folks are pretty sensitive to 'abnormal behavior' and funny smells these days. There were 2 'labs' busted within a mile of me a couple years ago, I had no clue.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
