Posted by JMS/.MN on March 16, 2011 at 19:47:44 from (209.237.107.155):
In Reply to: length needed? posted by 730 virgil on March 16, 2011 at 17:37:18:
A conveyor at a 45 degree angle should work fine. Others will too, but 45 is common. Measure ground to haymow, figure the same distance away from the barn. From that point from the barn, to the haymow discharge level, is 45 degrees. Vertical distance is "A", horizontal distance is "B". "A" squared times "B" squared equals "C" squared- that is the Pythagorean theorem. So, if A is 25 feet, and B is 25 feet (45 degree angle)- "C"squared is 35.35 feet. If you go to a steeper angle, you need a stronger motor to do the same job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
