Posted by Iowa Corn and hogs on March 10, 2011 at 06:11:10 from (75.105.32.52):
In Reply to: Tips for growing corn posted by Reid1650 on March 09, 2011 at 17:19:45:
These reccs are for the corn belt
1) Should have done the roundup last fall--awfully hard to kill sod in the spring
2) per #1, with $6 corn, I'd rip the sod up with tillage to get a good seedbed and slow down the sod. WAY WAY too much at risk this season--$1000 per acre possible gross this year. Too many chances for error no-tilling into sod not killed last fall
3) Make sure planter is in TIP TOP shape, and have trash whippers and seed firmers on the planter.
4) Use a RR hybrid with VT3 or similar stacked into it --lots of insects with sod, and protection later in the season as well. Order the best seed coating that's available--many insects in sod that will hollow out the kernal so it won't grow.
5) Drive 4.5 mph, plant THICK for your area
6) PLENTY of fertilizer, especially Nitrogen--split it--one application before planting, and a sidedress later
7) Don't be the first guy out planting in the spring--you want the ground warm so the seed won't have to struggle--sod is not very forgiving--even if ripped up it will re-establish and you want the seed to get started ASAP also.
8) "Ripping it up" won't totally kill it--the main goal here is a good seedbed--you will need to hit it with roundup again after planting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
