I agree with the suggestions about a bigger tractor needed for hauling manure especially if you are in hilly ground. I would suggest a 50-90hp tractor weighted to the 8,000 to 12,000# range depending on the size of the spreader. I have no experience with MFD assist to make a suggestion, but I would recommend renting any you think might suit your needs for at least a day before purchase.
Do you need to trim weeds and dry thatch back to 4-12" in the pastures or do you really need to cut brush? A good 3 point hitch tractor with an IHC 1300 9' sickle bar mower set up with a gauge wheel on the end of the bar and a limit chain to control the height of the inner shoe will let you trim 60 acres evenly in about 11 hours (if your ground is smooth enough to allow you to run 5-7 mph) on the least amount of fuel.
If you are trimming grass and weeds with a shredder, you will need about 3X as much hp to pull the same width as a sickle bar trimming grass and weeds.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
