Posted by jay-eye-see on February 24, 2011 at 14:46:25 from (75.21.114.221):
In Reply to: post hole digger posted by George Marsh on February 24, 2011 at 08:50:54:
Last fall I had 20 some holes to dig in clay with no rocks and had no interest in doing it by hand OR spending a whole lot of money. I bought this old Ford off craigslist for $250, then ran to the nearest Ford/New Holland dealer for $55 dollars worth of new cutters that they had to order. Then I mounted the whole mess on the back of a VAC Case with no down pressure and no live PTO and dug my holes in an afternoon. Maybe some folks would not care to be anywhere near it while in operation (B&D?) however it worked for me. It did so well with the engine at idle that I had to let it in slow so as not to let it screw itself into the ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
