Posted by IOWA NORTHEAST on February 24, 2011 at 14:33:20 from (206.72.18.89):
In Reply to: Re: post hole digger posted by Tom in TN on February 24, 2011 at 10:33:28:
Tom, If you take a chunk of steel, and bolt it to your auger about eight inches up, it will tear the soil to any width hole you need. Do not do this near the bottom, because your auger will drift out of the hole in looser soils.
We use a eight inch bit in a hand held, and we have hard clay soil in some spots. Any auger will dig if you sharpen the bit / cutting edge. I show some guys, the hand held will dig through a 7 x 9 oak RR tie if you give it lots of time.
If their is ANY flat surface on the bottom of your cutting edge, it will not dig. Always sharpen from the top side, and if it is dry, make it real sharp.
If you can take a butcher knife and cut the soil, a heavy post hole digger should never stop unless their is rocks, or frozen soil.
I have fixed alot of post hole diggers for farmers because they did not dig in hard dry soil. Many have sat for years in the corner of the machine shed, and can be purchased real cheap if you want to be dishonest.
One young man did not sharpen it, he rode it with a jacket on, while dad drove the tractor. Yea, you guessed it, he still has his left arm, but it is for looks only, and usualy it is under a long armed shirt.
If anyone ever gets caught with a dull blade, and only a few holes left, and you must apply down pressure........Stick a long crow bar, or shaft in the top, and lean on it way back away from the machine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
