I would almost just make 3 bridges to keep them off the ground. I have used them for all kinds of stuff and the bottom part that is in the ground is more often then not the soft part that makes them need replace'n (cept the ones I got from the ice storm two years ago, they wasn't soft just busted). Don't know how much you are think'n of spend'n but I'd at least lay them on rip rap if not bolted to a poured pad. Go on and make them 15'. I am have'n to put a poor boy oil field pipe bridge over one of my creeks because the co-op that does my spray'n traided in their 90" Apache for a Rogator that will not go in past 120" and my 11' culvert won't work good for them any more. Local Amish saw mill here will cut light poles into planks pretty cheap, have them cut them into three or four inch planks 15' long.
I would (and have) take all you have time and energy to haul or pull home.
I like the cable idea.
As for the corral idea, they are going to be a pill to man handle to get bolted to the post, going to take a lot of big post and bolts to get held up. At least have them sawed in half, and if you have critters that can bust through a half a 12" light pole, you don't need a corral you need a 30/30.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
