Posted by Roy Ward on February 19, 2011 at 19:50:51 from (69.19.14.35):
This lengthy but I wanted to cover the problem the best I could.
It has a deluxe remote control. Four remote plugin's that run the front loader. I added an open center spool valve to operate a double acting cylinder. In front of the seat on the transmission is a valve not control just a block, it had a line going to the remote spool where the plugin's are. Then out of that block and back into the tranny. I ran this line threw my added open center spool and back to the plugin's. Front loader still works fine. My added spool valve has no pressure output. There is a 1/4 inch line that goes from the the block where the 4 plugin's are and goes to the valve block on the tranny threw a check valve. I'am not sure whats going on. It looks like I have no pressure till you pull one of the front loaders levers and some how the check valve opens up or closes that lets flow into the pressure line. Question is if I remove the 1/4 inch check valve will that give me a constant flow in the pressure line. I hope someone out there knows how this 1/4 line works with a check valve in it works. Thanks for any help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
