Posted by JohnDeere720GA on February 14, 2011 at 08:22:01 from (66.156.100.240):
In Reply to: air compressor posted by 2cyl new d man on February 14, 2011 at 05:50:00:
If I read your question correctly you are asking if you can use a lp tank as downstream storage and asking about welding a drain into the bottom of the tank. If this is what you are asking then the answer is yes you can but the other answer is you dont need to weld in a drain. If you are concerned about moisture in the tank just mount it upside down so that the moisture would drain back into the line. You can add a dryer to the line if you find moisture to be a problem. Having a storage tank close to your work (end of the line) will help maintain a more consistant pressure while working. Your compressor will not run any less with this setup you will have a longer period of blasting followed by a longer period of recovery.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
