Posted by ncpapaul on February 14, 2011 at 06:36:20 from (130.74.33.151):
In Reply to: Broken Stud Removal posted by 1 Dollar on February 13, 2011 at 20:05:05:
Take a mig and dot-dot-dot-build up a small tip weld in the center of the stud, build it up taller than the surface, tap-tap-tap it with a hammer, then put on a black/plain steel flat washer and weld it to the tip, tap with hammer some more, then weld a nut to the flat washer, tap some more and take an air impact on low and slowly start back and forth, out first direction and then back in a bit and back and forth, going a bit more out than in, let the impact rattle or vibrate it, and usually I screw them out like that. Sometimes it takes several washer/nut weld-ons but it always beats an off center broken screw extractor in my book. Paul in Mississippi
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
