Posted by RayP(MI) on February 13, 2011 at 09:16:15 from (207.241.137.116):
I'd like to refer you to the link below. This is a reloading board. Many knowledgable folks there. They point up two Glock problems, you might want to be aware of. 1.) polyagonal barrels, 2.) chamber open to the bottom, allowing brass to bulge when fired.
The polyagonal barrel is a differnent type of rifleing, which leads to a looser fit between bullet and barrel - aledgedly! Also has been blamed for excessive lead buildup in the barrel especially when cast lead bullets are used.
The open bottom of the chamber was probably done to ease cartridge entrance to chamber. This however leads to the brass bulging into the open space when fired. If you're reloading that brass, it will be necessary to resize that brass to eliminate the bulge, or it won't fit back next time. Special dies, and possibly an extra step in reloading may be necessary, and brass life may be reduced (number of reloadings before you discard, or worse, have brass failure.)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Adding an Hour Meter - by Steven Gussey. This article tells how I added an electric hour meter to my 1942 Farmall H after rebuilding it. I wanted to keep an accurate maintenance schedule for my rebuilt engine and the implements I use with my tractor, but the H was never available with a tach
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
