Posted by jackinok on February 07, 2011 at 12:08:37 from (162.58.82.136):
In Reply to: Re: Work Shop posted by Danny Prosser on February 07, 2011 at 10:49:14:
thats right barrier to the inside ,heres how it works, heat travels from hot to cold(ALWAYS).when heat goes through walls (and it will) it picks up moisture inside insulation and since colder air doesnt hold moisture as well it it takes it outside where it evaporates. if it cant get through a vapor barrier it will build up and cause mold ,warping of walls ,rot and all the other bad things.one reason tin has ridges ,besides adding strength is to allow air circulation to avoid moisture buildup.since your air conditioner ,if you have one in your shop in summer removes moisture in the form of condensate,it dries the inside of building and vapor barrier stops moisture from building up on inside walls in summer.this does cause insulation to hold more moisture,but since the only way it can go is out,and since the cooler surface does not hold moisture it dries quickly just from simple air flow. those folks who say they have sheetrock warping problems probably have NO vapor barrier.what this does is cause moisture to build up inside sheetrock simply because moisture is always there,traveling one way or the other, especially if you are heating inside. in a real bad case, you cant even paint a wall!.moisture will go one way during day and the other way at night. you paint a wall during day,come back in the morning and paint has simply washed off walls onto floor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
