The design is the responsibility of the engineer... to the point that he needs to know what the typical worst case is and build for that. If his design is inadequate then the owner would have recourse to sue him... and that has happened in this general area. Again... my assumption here is that the design ~will~ be adequate for local conditions... and if for some reason it did collapse, insurance should pay. Those are the one in one million cases. If someone allowed 6' of snow to accumulate on a roof, saturated with water... then that's there own damn fault. The engineer can't anticipate or reasonably build for that neither should insurance be expected to cover it. With our coverage we have collapse for wind but snow load is different coverage and they inspect every building on a per case basis for both. Actually they inspect electrical and heat sources annually as well and if it doesn't meet their specs (which are tighter than code in some cases)... you get a letter and a date for rectification... or they remove that building from coverage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
