Not sure why you would need to protect yourself from 1000 yards.
I found the M1 Garand to be way to heavy. Only good for snipping. Only holds a few rounds taking your eyes of the emeny to reload.
I have a M1 Carbine. 30 round clip and good for anything between 50 and 200 yards (300 with pratice). Light weight, easy to move about with.
30-30 would be my choice if I didn't have the M1. But with it you have to cockit taking your gun off target. M1 is semi-auto and I can put three shots down range in the same time your sighting in your second shot.
Little closer and I op't for a short barrel 12GA. First shot a slug followed with a buck shot. After two shots your goning to be looking for the next target.
Hand guns I am still looking. I have a 45 semi-auto that I like for the speed and reloading. But its kind of heavy. 357 revolver is OK shooting but reload is a PITA and not good if you need it fast. Friend has 40 semi-auto that I am itching to try out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
