Posted by Moline_guy on January 23, 2011 at 21:34:08 from (216.106.219.144):
In Reply to: 1983 3/4 Chevy 4x4 posted by Old Chevy on January 23, 2011 at 19:37:40:
Good trucks and getting hard to find. Not sure if the 3/4 83 would have the aluminum transfer case or the 205 cast one, but either way they are well built. I think the rust was a bigger issue on the mid 70's ones, but the paint on most of the early to mid 80's have a problem of flaking off. By now most have probably been repainted. Around our area these type of pickups in average or above condition will outsell ones from the late 80's and early 90's. No computers to mess with just nuts and bolts, and kind of a rough ride, but thats the way a truck is suppose to ride.
This is my 86, it is a 1 ton with single rears and a 454. It has the cast 205 transfer case, same as my 77 3/4 ton did. My 86 1/2 ton has an alluminum 208 transfer case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
