Posted by old on January 23, 2011 at 20:01:13 from (4.245.14.127):
In Reply to: 1983 3/4 Chevy 4x4 posted by Old Chevy on January 23, 2011 at 19:37:40:
I run a 1980 Chev 4X4 with a 350-4 bolt main with a 4 speed. It is a heavy half which has been rebuilt with over load springs etc to haul a bit more and it does well. It has 3:07s in it so it is a bit on the tall side when it comes to pulling but I get 17 mpg when tuned up. I have scaled out at over 14,000 a few times so a 3/4 ton should have no problems with what you want to do. Payed $1200 for this one about 7 years ago. Big problem with the Chev is the cabs rust badly and the cab mounts go bad and the cabs sag
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
