Posted by 135 Fan on January 22, 2011 at 21:04:13 from (68.149.56.30):
I went out to my 80 acres to clear the driveway and shovel the snow off the 5th wheel trailer. A guy that goes out there sometimes hand shovelled the driveway once about a month ago. It's a 1/4 mile long with some curves and it took him 8 hours over 2 days! He e-mailed me after the fact, otherwise I could have gone out and cleared the driveway. The snow was about 2 feet deep(a little less where it was shovelled but had a crust on it and the bottom was hard packed. I didn't have the chains on the tractor but it wouldn't have gone far anyway. So I got my 4x4 3/4 ton, which was parked there, unhooked from the trailer and somehow managed to get it turned around so I could boost the Cat loader. I was pushing snow when I opened the door to get out of the truck. I got the Cat going and proceeded to open the driveway. The bucket is 6 ft. wide but I sure wish it was at least a foot wider. If I only had to do one pass down the middle wouldn't have been bad but a track loader with street pads is a poor machine for clearing a driveway. It will go through almost anything when pushing straight ahead but if you have to turn, the one track just spins because they pack with snow. It took about 3 hours to get the driveway open, where the skid steer would have done it in about an hour with an even smaller bucket. I guess it's why a skid steer is a lot faster spreading topsoil too. I did get down to the gravel and levelled the driveway in the process though, which was needed. I don't think much gravel came off, just some sand. The rocks in the gravel were pretty packed down from all the rain last year. The skid steer would have been so nice to have there but oh well, I at least got er done. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: Choosing the right one - by Chris Pratt. They cost less than the tax on a new tractor (at least where we live). They have the weight to do the job. They are simple and understandable. They even have a history and can be restored to become a major source of pride and enjoyment. But how do you know what to buy and how do you make the right purchase? There is a surprising number of machines available in every shape and size imaginable. Like most things in life, your needs have a lot to do with wh
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
