Posted by jdemaris on January 11, 2011 at 06:34:26 from (67.142.130.32):
In Reply to: Re: Steam power . . posted by WA-Hal on January 10, 2011 at 18:36:14:
I wasn't alluding to steam power being viable for the masses. Steam power, or wood-gas-capture however, is something a person can use and get around with - during a petro-shortage - when all else is stopped in its tracks. A person or family can also run a tractor and farm. Wood-gas capture kept many an electric generator and farm tractor going during WWII.
If all fossil fuel products were cut off to the public tomorrow, what do you suspect would be happening in 3 months? Especially in cold areas during the winter. No gas, no LP, no NG, no coal, and no electricty. Many with no heat, and many more with no means of transportation. Unless you live next to a coal-mine, it's likely wood will be the most available local fuel. That and a few solar panels and wind-generators.
In regard to any new technology in the horizon that has even a hint of hope for long-term energy? I haven't seen anything yet.
At present, the idea of electric vehicles is rediculous. They are mostly, in effect, indirect coal-burners.
I'm wondering what sort of technology you think is "developing rapidly" that provides a long-term, sustainable energy plan? I try to keep up and when reading closely, I've seen nothing so far. And even in spite of that, collectively we've done nothing to cut back on energy waste.
I'm on 100% solar, and that works fine for me. But, I also know that solar provides NO promise on a mass-scale. I only got it, due the Federal and State incentive programs that force all taxpayers to subsidize it.
At present, a dollar spent on energy conservation has a much higher return-yield than a dollar spent on alernative fuels or alternative-fueled -cars. Note that an electric car is not using a new fuel. It's just using coal as the primary fuel-source - with a lot of tech inbetween the coal-mine and the car.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
