Posted by JDseller on January 10, 2011 at 21:44:58 from (208.126.196.144):
In Reply to: mower/mulcher? posted by dave2 on January 10, 2011 at 04:51:02:
Dave that is a basic flail/shredder mower with cup knives. I think you would like the job it would do. The only draw backs to these type of mowers are: 1) If your grass gets thick and tall they will take horsepower to pull. 2) In coarse stemmed stuff that is tall they will bent them over and strip the leaves off but will leave the stem. The cupped knives will reduce that but the real wood stuff you might have to go over in opposite directions.
Advantages of these mowers: 1) they shred everything up into a small size and spread it evenly. They don"t clump stuff up like a rotary mower will. 2) They will suck up downed material very well. I have used a MC rotary scythe in downed hay. It just pulled real hard. 3) They gage the cutting height off of the rear roller. So if you just let it float on your hitch they follow the ground very well. 4) They will suck up the biger clumps of manure and shred/spread them too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
