Posted by NCWayne on December 29, 2010 at 08:58:39 from (173.188.168.198):
In Reply to: Need Help w/ oil pan posted by Poor farmer 830 on December 29, 2010 at 08:17:54:
Never hanged one of those gaskets as I work on construction equipment so I"m not sure exactly what the problem your having is. That said if the problem is the oil pump sticking down into the pan preventing you from getting the gasket into place (ie-the pump needs to be in the middle of the gasket to get the gasket in place) that problem can usually be handled with no problem. I say usually because I know there are lots of newfangled gaskets on the market nowdays that can"t be cut due to their shape, etc, but assuming you"ve still got the old style, flat type gasket then it"s not a problem. What you do is chose a spot on the gasket that will be easy to get to with the gasket in place on the pan or block, whichever way you plan to put it up. With the place chosen, and using a sharp razor knife so as to leave a clean cut, cut out the shape of a dove tail across the gasket. Once cut you"ll have two ends of the same gasket that will interlock once in place. Doing this will allow you to get the gasket around any obstructions in the center of the pan and also provide a leak proof seal once the pan is tightened up. For extra leak proof assurance you may want to put a little dab of sealer, such as Ultra-Blue, where you make the joint, but to be honest it"s not usually necessary with a good, clean cut joint. Manufacturers do this type of joint, or varients of it, all the time on oversized gaskets without any problems and with a little care in making the cut anybody can do it with good results also.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
