I'll second sending them down I-80 or maybe I-90 instead of I-94.
www.511MN.org is the Minnesota DOT site for road conditions
www.511IA.org has Iowa road conditions.
In central Minnesota roads are cleared with normal winter driving (some snow pack in spots). I haven't been on the interstates.
The weather forcast here for Thursday & Thursday night is 20 to 40% chance of snow flurries and light snow showers with light accumulations of an inch or less. We have 18 inches of snow on the ground and the high today (Wed) was a warm 30F.
Relatives in Omaha say the grass is showing in spots on their lawns.
How experienced are your drivers? You may want to steer them around larger cities as much as possible.
I-90 through Minneapolis will be congested with up to 40 miles of possible stop and go conditions on the interstates from 7am to 9am and from 3pm to 7pm and later. I-696 around the north side of town will be the same distance and somewhat easier than traveling though both downtown Minneapolis and Downtown St. Paul. I-494 around the south side of town is longer and is always more congested, avoid it.
Sioux Falls, SD; Des Moines, IA; Quad Cities, Ia & IL; and Madison, WI are all medium size towns that are much easier to drive through most anytime of day.
Chicago will be a bear anytime, especially if you come from the north and drive through all the western side of town. I-80 from the west by-passes the west side. Avoid rush hour in Chicago.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
