Posted by IOWA NORTHEAST on December 15, 2010 at 09:55:20 from (206.72.18.89):
In Reply to: OT - Auto Tire Cables posted by M-MAN on December 14, 2010 at 21:35:23:
We had them on every fire truck at one time, now we have tossed them.
We went to the regular tire chains with the cam latches. We however do not try to drive the 35 as mentioned.
The cables were ok, but when breaking, you have to let it roll a little as you break, otherwise the cables are not in contact with the ice.
I do not recall them ever being a side slid problem, as they do cut into the ice somewhat.
In any case, they are well worth the cost compared to nothing at all.
Make yourself a small board with blocks added to make a place for the cross bars to drop into, lay the chain into the slots, then drive up on the 2 high block. You will hug yourself for doing that, even with regular chains.
I'm poor at explaining things, but it will look like a ladder with the rungs sunk dowmn for the tire chais to lay in where the ladder rungs would be. The block of wood only needs to be 18 inches long for a large truck, and about a 6 inch wide board.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
