Posted by Grabatire on December 12, 2010 at 09:38:43 from (173.210.180.23):
In Reply to: Tractor across Canada posted by Chas. Ont. on December 11, 2010 at 16:31:11:
There were several tractors manufactured or assembled in Canada, but very few were Canadian from the roots. Massey-Harris and Cockshutt were two Canadian companies that although they sold tractors made by others at times, they did have their own too, albiet with Buda, Chrysler, Continental or Waukasha engines.
With that in mind, I would compromise with a Cockshutt 1800 or 1850 series diesel with a cab. They are actually Olivers, but they are easy on fuel and have a reasonable road speed with power to handle the hills if pulling a small trailer. My closest true Cockshutt choice would be a 570 or Super 570. I"m not sure if they ever came with a cab so one would need to be fabbed up. We farmed with a Massey-Harris 55 gas with a cab but fuel consumption would be an issue.
My choice for tractors other than the above would be a John Deere 830 or IHC SWD9. The 830 is easy on fuel, rolls along at about 15 miles per hour and has ample power for the hills. The SWD9 is about the same power, has a higher road speed but a bit more thirsty.
Finally; unless your nephew is travelling alone, an operators area that allows seating arrangements for two must be considered.
It will be a great experience no matter what tractor is chosen. We all look forward to the book.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.