Posted by Grabatire on December 11, 2010 at 11:15:11 from (173.210.180.23):
In Reply to: TD 6 Crawler engine posted by JDS1 on December 11, 2010 at 08:19:53:
I"m sure it just slipped rustyfarmalls mind, but there are a few other things to consider. You will also need to change the mounting plate on the rear of the engine as well as use the flyhweel from the TD6 to facilitate the starter. The oil pan and oil pump on the crawler engines are designed to allow operation an steeper grades than is the MD wheeled tractor, so those should be swapped as well. Also, the crawler engine uses a dipstick to measure the oil level, whereas the Farmall uses petcocks located on the pan which are not accessable if the crawler has a belly pan. There is a spot on the MD engine that can be drilled and tapped to accept the drop tube and dip stick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
