Posted by Mark - IN. on December 09, 2010 at 20:15:48 from (68.60.243.216):
In Reply to: Re: Ram Fuel Pump posted by Mike M on December 09, 2010 at 19:31:11:
I agree. Been there, done that, nearly full tank as well. Couple of screws hold the filler neck, couple more hold the straps, was a pain getting to the connectors at the fuel pump. Was not easy, I remember that, but if think handling a full tank is tough, handling a bed after undoing the electrical or the lighting has got to be harder.
One thing is for sure. I remember was a very small retaining clip of some sorts at the fuel pump. Can't remember if was fuel line or electrical, but was fragile and I broke mine...a locking tab, and Dodge garages do not stock it, so it had to be ordered, and as turned out, had to be ordered from another Dodge garage that ordered one but did not need it, so had it setting on the shelf. It took a week to get it, so be careful because that was before Chrysler went belly up. How long to get one now? May not even get one now...especially after the whole cash for clunkers thing. They may not even make it anymore for that reason alone. Hey, I still have my '96 as well and am going to get a million miles out of it.
Regardless, when you start unconnecting stiff around the fuel pump, be very careful. Is a small locking something or other that is very fragile, if for no other reason than age. DO NOT BREAK THAT LITTLE FRAGILE LOCKING TAB, or you will hate yourself. With the Christmas holidays coming up...don't do nothing to be hating yourself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
