I see the pallet forks in the foreground. That's still hard work man handling the peices. We did the same when thefamily sugarbush was still in operation. We fueled tow evaporators. One a4X20' and a 5X24', Grimm's made in Ruttland VT. I can remember as a teenager running limb wood through a buzz saw on the front of the CASE SC, and splitting 3' wood by hand with mall and wedges.I thought back then that there had to be something easier than that. When I got out of college in 68 Ag Engineering Associate degree in Ag Engineering, I found a peice of 12" I beam, ordered a 4"X 3' hyd cylinder and single spool valve and fabed a wood spliter to handle the evaporator wood, My dad got the bill for the hyd components and chewed me a new A Hole, untill we put it to work. We made several modifications and repairs to it, over the years but we finally took it off Dads Case 770 4 years ago when we restored the tractor we sold the old homemade splitter for more than the cylinder and valve cost and used it for 38 years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
