It's a Galion, works extremely well. I've got another Galion, but it's a motorgrader and is geared too high for here. Cannot back up my 13% slope driveway. 1st gear is faster than I'd prefer.
For cutting, 4x4 is better and I've got great speed control. This will even create side ditches. Offsets 2 ways, blade tilts both directions, even the rear axle is steerable. It's a wonderful machine. The front axle will go under the frame, allowing it to turn around in the same space the tractor requires. The only difficulty is backing it up.
Anybody thinking about a maintenance machine would do well to look for one. Old's not the only low price seller. Used solo, I occasionally have to stop and go back to make an adjustment, but not often. With practice, you learn how to get it set about right.
I've seen single axle models, never tried one. Well, I've got a steel-wheeled homemade version that's got a huge tank for the cutting edge, tilts side to side but won't angle. A whole lot better than a rear blade, but not quite like a real grader. And yes, a rear blade does live here, don't remember when I last used it.
At one time I was looking for a Huber Maintainer, but those prices are out of sight around here. Especially ones with the front dozer blade. If under $10k, you're buying a project.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.