Posted by Scott in SF on November 26, 2010 at 16:37:55 from (76.240.231.196):
In Reply to: o/t sighting in a rifle posted by johndeereman on November 26, 2010 at 14:19:16:
Every scope/rifle will be different with most of the difference being how high the scope is mounted above the axis of the bore. Most scopes adjust 1/4 inch for each click at 100 yards. . 4 inches low at 40 yards is probably 12 or so inches low at 100 yards. GordoSD ( I grew up hunting in ND) is right, if it was me I would crank in 10 clicks up and see where it hits at 100 yards. With a flat shooter like 270 I zero 2 1/2 inches high at 100 yards. Then forget about hold over, up slope down slope ect. out to about 325 yards. It dosen't matter to the deer if your heart lung is shot 3 inches high or 4 inches low. Wind will get you a long time before drop does. I suggest a internet search of Maximum Point Blank Range , or as we called it in the Army, Battle Zero. The only thing ever shot at 100 yards is paper. Most of the rest is from 30 feet to 300 yards. I like to pick a zero that will work for all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.