Posted by RSCO on November 16, 2010 at 13:00:11 from (64.136.26.228):
In Reply to: Metal Building posted by Soldier Tom on November 16, 2010 at 10:44:25:
I spent my working life in the building business; houses, not farm buildings, but I'll pass along my thoughts. I'm not sure what you mean by a gully, but if it's what I envision, I wouldn't do it. It sounds like a trap for snow and water and that will lead to rust on a steel building.
2nd point: put plenty of steel in the concrete. Run at least #3 (3/8")rebar at 18" o.c. each way and make sure the rebar is pulled up to about the midpoint of the slab thickness. The rebar will control cracking and prevent heaving or lifting along any cracks that do occur. I assume you'll also have a thickened edge and that your plans specify rebar for this.
3rd point: Score your slab at no more than 10 ft. intervals each way. The purpose of this is to create a weak point so that the slab will crack where scored rather than haphazardly. If you plan to use your building as a shop, then I'd score it with a saw as this will make it easier to roll items like floor jacks and creepers over the score lines. If you won't be using it as a shop, then a parting tool is probably fine.
In case you're wondering about my concern about cracks, concrete will crack. That's something it does since it shrinks as it cures. The purpose of the steps I've outlined is to control the cracking so that you get a good floor that lasts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
