Posted by NCWayne on October 31, 2010 at 20:14:25 from (98.21.228.96):
Question for you computer wizards out there. I'm working on bidding on a small job and was sent an email with a blueprint. As expected to view the thing on the computer screen you have to blow it up to nearly 200% and scroll around. That makes it really difficult to see the actual layout of things as they relate to each other. My problem is it's in Adobe and evetrything but lookig at it it is restricted. Heck it won't even allow me to make a print copy of it. Other than blowing it up on the screen and using a digital camera to take pics of it and then printing them out (which only semi works as I've tried that to at least get a copy of the part I'm bidding on to work off of) what can I do??? So, my actual question here is is there any way to 'force' the program to allow me to print the file, or do anything with it other than look at it one piece at a time??? Any suggestions would be greatly appreciated.....It does say something about getting 'permission' to be able to print it, etc but says nothing about where said permission can be obtained and the sender has no clue about that part either.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
