I've got to disagree with some of the other "easy" comments for a 6"/1' pitch roof. Maybe somebody's has some magic anti-gravity tricks I'm not privy to - but I've worked on many steel and coppper roofs over the past 40 years. With a warm dry steel or copper roof, and wearing soft-sole sneakers - a 5"/1' pitch is about the safe "easy" limit. A 5.5"/1' pitch gets slippery, and a 6"/1' pitch almost impossible to walk safely and carefree. I just finished a steel roof this week that is all 5.5"/1' pitch and it was not easy and sure walking. When the sun came out and the steel was warm and dry, I could walk it, for the most part, with just a few slips and slides, now and then. When cold in the morning, or damp - I had to have something to hang to with hands for insurance. I'll add this was an exposed fastener job, so I had the raised screw-heads to help me get traction. With no exposed fasteners, it's even worse.
Asphalt of course is different. The old farm house I just did, was all alphalt at first with the 5.5"/1' pitch. No problem walking except when the occasional shingle broke to pieces, But, once the steel was on - no way was it an "easy walk."
I also recently finished a steel roof in the Adirondacks. 6"/12' pitch. Absolutely, no way could it be walked saftey without using ropes for hand-hold safety. I throw a rope over the roof and fasten somewhere on the other side. Then keep it tied to my belt or wrapped around my arm.
One comment. I'm only 5'9" and weight 150lbs. and have pretty good balance. Been working roofs and climbing trees much of my life. I'm not a huge guy that might be a bit more unstabile.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Field Marshall Tractor - by Anthony West. Any restorer who has some knowledge of turn of the century farm machinery, will recognize the name Lanz Bulldog!! This machine was to say the least unusual in its appearance. The huge flywheel and coffee percolator shaped exhaust. Along with square body lines and cylinder head protruding forward of the front axle. Would become the visual differentiation that people would quote to separate the Lanz from other period machines. The Marshall company based at the Briannia Works in Gainsborough
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
