Posted by Janicholson on October 13, 2010 at 19:58:41 from (67.72.98.45):
In Reply to: Hello! New here! posted by Hoosierhog2 on October 13, 2010 at 11:55:19:
Make sure these things are set correctly: The plow will have a specific cutting width per moldboard. This is measured from beam to beam at 90 degrees to the furrow. It will be 14" 16" or 18". This size is important when setting it up. When plowing the second pass, the right front and rear wheels will be in the furrow made by the first pass (assumes a wide front end). Put the plow in the ground and the wheels in the furrow. go forward about 20 feet in the furrow. Stop the tractor with the plow in the ground, and shut it down for a few minutes.
Use a tape measure to measure between the left vertical edge of the furrow (behind the rear tire in the furrow) to the colter on the first mold board (disk like splitting unit in front of the shiny moldboard.) This measurement must be very close to the same as the plow size determined above. If it is way off wide, or narrow, it will be necessary to adjust the tractor wheel width to get it to the plow cut. Adjust the wheels (front and rear) in or out the difference of the measurements.
Next measure the depth of each of the two points from the surface of the ground, to the cutting tip of the plow point. they should be within 1/2 inch of each other and about 6 to 7 inches deep. You will need to dig them out to find them with a tile spade or hand trowel. If they are at different depths, the right rear three point link must be adjusted to make them level with the tractor in the furrow.
If these terms are unclear, you are going to need a helper on site that has plowed before. The tree pits are a problem, but a rented box blade will fill them pronto. Then plowing is easy.
Best of luck, plow setting is not difficult if you already know how!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
