Posted by Hoosierhog2 on October 13, 2010 at 13:16:01 from (32.178.106.107):
In Reply to: Re: Hello! New here! posted by John S-B on October 13, 2010 at 12:40:05:
Youd be supprised at how well they fill in. normally when they came to take trees they would take 100-150 and all in a row so i would run the mold board down one side and back up the other throwing the dirt in and then disc it down and you would never know there where trees or holes there worked great problem plowing is now that the trees are gone and im making more than 2 passes. Trying to plow the whole field it looks like im just tearing up the ground there are huge clods and chunks of sod that dint turn all the way and its a rough ride tring to disc it down. ive only plowed the area the trees were so far and some further out into the open portion where the trees were taken last year but im deffinatly doing somthing wrong. i know people farmed with smaller tractors back in the day and my plow is probably ment for a 8N and i cant imagine a 8N trying to disc this down i doubt it would even be able to drive through it. but i need to figure out what im doing wrong before i do the rest of the field. r
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
