Posted by Jg20601 on October 10, 2010 at 14:46:33 from (65.55.67.186):
In Reply to: Wheel Width posted by LarryT on October 09, 2010 at 18:42:26:
There is no standard width for tractors. Width is usually determined by the purpose it was built for. Is it possible to shift the plow in the direction needed? What seemed to be the problem with the Ford 800? My book lists them at 45hp - which would seem to be enough I have a Farmall 140 that I used for plowing in the 80s and 90s. It is 28hp with a Mccormick 215 2 bottom plow.
Most Super As to 140s around here are 48" wide, mine is 52"... but you could order them up to 100" wide according to a paper my uncle had. Most are 48" because that is easiest with the one row cultivator.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
