Posted by John S-B on September 29, 2010 at 19:25:21 from (205.188.116.74):
In Reply to: Best/wost cobble jobs posted by C.R. on September 29, 2010 at 18:37:38:
I'd say the best one is a tie, both done by myself. (Hope I'm not bragging too much!) The first was when I was on a National Guard weekend out in the field. The Sergeant Majors jeep was about out of gas and no one had brought out a nozzle for the gas cans. I knew there was an old pile of rubbish where we were so I looked though it and there was an old glass 2 liter bottle (remember those?). I was a mechanic at the time, so I had my tool box with me. I used a triangular file to etch a line around the bottle at the bottom, then I held it up to the exhaust of a generator to get the glass hot. then I poured some cold water on it and the bottom of the bottle broke off clean. Instant funnel to fill the jeep with gas! The other one was that I used a small hose clamp to connect a broken link of square drive chain on a manure spreader. It held for two years until I quit using the spreader. The worst cobble job I've ever seen was when someone tried to plumb a drain line in a house for a bathtub. They used ABS sealed with roofing tar. It was discovered when the pipes fell apart taking the kitchen ceiling with it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
