Posted by Bob on September 29, 2010 at 07:38:28 from (69.178.228.68):
In Reply to: 8n troubles posted by medicrick007 on September 29, 2010 at 07:18:25:
It's hard to tell WHAT your problems are over the 'net!
The governor problem COULD be due to mis-adjusted linkage, internal governor problems, the carb butterfly and shaft mis-assembled, or the locations of the two rods swapped around at the governor.
The "have to open up the mixture screw" problem could be plugged passages in the carb, worn, swapped or missing jets, something wrong in the venturi area, or even a bad gasket.
Also, valve problems, a manifold gasket sealing problem or even a manifold with an internal defect can cause problems like that.
If you want the maximum number of "GURUS" to mull over your problems, post this on the "N"-specific Forum linked below:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
