Posted by Brad Gyde on September 20, 2010 at 20:30:00 from (68.28.137.230):
Hey guys,
I'm curious to know how one would go about setting up a moldboard plow to a tractor.
I ask this question because last week I helped a co-worker set up a Oliver trailer plow (3-14's) to his 560 IH. We are both a lot "green" on the subject, as not many have plowed around here in my 29 years (and even fewer used a old trailer plow) and the co-worker isn't a great deal older than I am.
We asked several folks locally that play with tractors and plows, but got a different way to do things from everyone we asked, so we did what we thought would work, and it seemed to plow ok at a plow day Saturday, but I'm really curious to know if we were on the proper track, or not even close..
Just cause it seems to work don't mean we did it right.. And I'd like to be a little knowledgeable on the subject.. Was always fascinated by plowing, and would like to learn more about it so maybe someday I can help a younger generation learn the technique as well. (but I have to do a bit of learning to pass down any knowledge)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.