Posted by Rod in Forfar on September 07, 2010 at 16:39:39 from (64.118.28.136):
In Reply to: new to tractors posted by hitman on September 07, 2010 at 12:43:46:
Welcome to the board. You'll find contributors here are very helpful, and by and large their advice is as good as you will get anywhere.
I'd vote for the 135 because six years ago I was in your situation and a lucky purchase of a 1960 Massey Ferguson 35 with Perkins Diesel (many hours on a broken tach) has served me very well for about six hundred hours to date.
A neighbour converted an old Freeman trip loader to full hydraulic, including downpressure on both the lift and the tip functions. With the reinforcement, controls, new cylinders and hoses, it came to a $2200 upgrade for the '35. And it was worth it. On the other hand a new loader would have looked better and had more strength, so it's a trade-off.
Operating a loader on a 135 involves learning to manipulate the diverter valve which directs flow either to the 3 pt hitch OR to the loader. It takes some learning, but the system works.
Make sure there's lots of room to get on and off the tractor with the loader installed. The Freeman was a tight squeeze for me, so I had the welder move the post forward about six inches on one side. It was still strong, but a bit lopsided. The only time I regret the asymetric mod is when I look at a picture of the tractor; the rest of the time it's great for getting on and off.
Your tractor will become very important for snow removal. Start looking for a deal on a 5' snowblower. Don't worry that it's 6" narrower than the tractor. 135's handle 5' bush hogs and blowers very well. You will need a serious snowmobile suit, full-shielded helmet, and most importantly, heavy, waterproof mitts. Blowing snow from an open tractor is a real man's job. But it works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
