Posted by John A. on August 31, 2010 at 22:22:57 from (76.1.122.180):
In Reply to: Stuck piston posted by Pony1952 on August 31, 2010 at 12:39:35:
Pony1952, Fill the cylinder up with Diesel, add a splash of Gas, set the mixture on fire, drink a cup of Coffee while it burns itself out. The amount of volume that last stuck cylinder has will dictate the burn time, if the piston is near TDC the burn time is short, you may need quite a few burns to get the rust to break loose, if it more toward the bottom of the stroke the burn time will be longer so only 1 or 2 burns may be necessary. As always, remove all flammables from the area, remove the fuel tank and get it away, and roll the tractor outside if possible. If you haven't cracked the piston this method will work in short order. Hope this helps! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
